To Install Garage Attic Fan

Aug 8th

Garage attic fan – The best place to put this type of fan is in the attic. You may be worried that there is already a ceiling mounted overhead light, but if the small amount of space over. By following a few simple steps, you can wire up the fan and make it carry steam and overheated air to the atmosphere. Make sure that all power to the garage is turned off at the wall outlet. If you have a breaker box in your home, remove the one that starts up the garage. You should then remove the light fixture by tightening it and pull it so it hangs down with cables exposed. Remove the electrical wires as this will be required by your garage exhaust fan.

Best Garage Attic Fan
Best Garage Attic Fan

Select the area where you want the garage attic fan to be and then cut it around using either a hand saw or a power tool such as a stick saw. The hole should be as close as possible to the electric box to the light. Once the hole has been made, locate the electric box and screw it. Pull the wires inside the box. Pull down the wires and connect them to the fan. You then need to screw the individual connections, add the correct wire, and then tighten screws using your screwdriver.

12 Photos Gallery of: To Install Garage Attic Fan

Image of: Best Garage Attic Fan
Image of: Twin Garage Attic Fan
Image of: The Garage Attic Fan
Image of: New Garage Attic Fan
Image of: Install Garage Attic Fan
Image of: Good Garage Attic Fan
Image of: Garage Attic Fan Picture
Image of: Garage Attic Fan Photo
Image of: Garage Attic Fan Image
Image of: Garage Attic Fan Ideas
Image of: Garage Attic Fan Decoration
Image of: Garage Attic Fan Blade
 

Unscrew the drain hose following the instructions, and then push it through into the room above the garage. Using a ladder, make a hole at a time of the garage near the exhaust pipe, and then push it through. Close the edges of the hole using caulk or similar sealants. Now that the fan is wired and the exhaust plugged in, you can fit your garage attic fan on the wall. You may find that you have a connected hood that is to be screwed around the whole first and the fan is connected to this. Unscrew support from the fan on the ceiling spikes, and then seal around the hole using a caulk. Make sure there are no holes along this seal and turn the power back on to your garage and check the fan. The light switch will now turn the fan.